All tube - 100W - small size housing - incl. Foot switch
• 2 channels: Classic / British - Separate gain and volume controls for each channel
• 100% handcrafted in Germany • 3 year warranty
• Price: € 1990 (special limited advertising price) + shipping / in stock
When developing the British Legend amplifier, special attention was paid to detail.
The goal was to pack two of the best guitar sounds into one amplifier and provide them with more sound options. The perfect arrangement of components resulted in an amp that offers two legendary sounds and at the same time and some additional features that are unique.
100W in a small size housing (20.08 x 8.66 x 8.27 inch) and an acceptable weight of 37.5 lbs ensure easy handling.
The British Legend Classic Amp is handcrafted with attention to detail in my workshop. The wooden housing is made entirely of birch multiplex, TOP quality.
All work: production and assembly, installation of all components, wiring and testing are made exclusively in our workshop. Only high-quality, selected components are used.
Amp, design, circuit, wiring structure, sounds, layouts as well as the complete construction by Ulrich Rodenberg.
• Twins switch - on the rear
Middle position = 1x channel Classic and 1x channel British available
Down position = 2x channel Classic available
Up position = 2x channel British available
• Feedback switch - on the rear
Works with the main amplifier section
Down position: Soft feedback for bluesy sounds
Top position: Tight feedback for strong basses and fast solos
• FX Loop
FX loop loop • serial • buffered • switchable on the amp and by foot switch. The active FX loop is located between the pre- and main amplifier. The signal is low-impedance and can therefore drive long connecting cables without loss of sound. The return jack can be used as the main in to the power amplifier. The FX loop can be switched on the amp itself or via a foot switch (not included). When activated (without effects device), there's (almost) no loss of sound.
• Line Out
Line output - adjustable level
Level controlled, here you can install a speaker simulation box to send the signal direct to the mixer.
Attention: A speaker or cabinet must always be connected to the British Legend Classic outputs!
• Output jacks impedance:
1×4 / 2×8 / 2×16 Ohm
• 2 channel foot switch
Switching from channel Classic to channel British
Jewel LED indicator for channel British ON
Connection: Standard guitar jack cable, cable detachable on both sides
• Voltage selector switch for 100VAC / 120VAC / 230VAC / 240VAC
• Channel Classic:
Gain - Bass - Middle - Treble - Volume = Legendary British rock sound (Plexi sound with a little more gain)
The Classic channel shares the tone controls with the British Channel. The Classic channel reflects the sound of the legendary Plexi amplifier.
Slightly optimized and with a little more gain, it shows its strength in the slightly overdriven sound, but it also can dial down to clean sound
with the Gain and Volume controls.
Gain - Bass - Middle - Treble - Volume = legendary British rock sound (HOT ROD sound with medium to high gain)
The British channel shares the tone control with the Plexi channel. Slightly optimized and equipped with more gain, it shows its strength
in medium gain up to high gain sounds. The rock sound of countless recordings.simply the rock sound of countless recordings
• Technical specifications:
Selected capacitors • Carbon resistors
Jacks for 4 / 8 / 16 Ohm speaker and cabinets
Illuminated power switch on the rear
Voltage selector switch 100V / 120V / 230V / 240V
IEC socket + main fuse + anode fuse (internal)
Housing • Birch multiplex • Elephant covering • Gold piping
Small size housing: (20.08 x 8.66 x 8.27 inch) • Weight: 37.5 lbs